Step-Up Voltage Regulator U3V40F6 - 6V 4A - Pololu 4013

Бестселлер
53916959
1 447 ₽

Мы сотрудничаем с поставщиками электрики Pololu и предлагаем вам самые выгодные предложения на брендовые товары из Америки. Опираясь на свой многолетний опыт, выбираем только лучшие позиции из аутлетов и дискаунтеров, чтобы предоставить вам оптимальные цены, в которые не включены дополнительные расходы на аренду торговых помещений.

Доставка товаров осуществляется прямо с нашего склада до указанного вами адреса. Вы получаете оригинальный товар по цене, которая недоступна для местных магазинов. В нашем интернет-магазине вы всегда найдете широкий ассортимент брендовых товаров с выгодными скидками.

Мы следим за каждым этапом вашей покупки и предоставляем отслеживание заказа на всех этапах, начиная с момента оплаты.

  • Бренд Pololu
  • Доставка из Польши
  • Почта России 23 июня
  • Стоимость доставки заказа в Россию от 1 350 ₽

Сроки доставки указаны ориентировочно и зависят от региона доставки. Подробнее на этой странице

Характеристики

Напряжение до
1.3 V
Напряжение от
6.0 V
Выходное напряжение от
6.0 V
Выходное напряжение до
6.0 V

Общие характеристики

Стабилизатор - Тип
step-up

Прочие свойства

Бренд
Pololu
Номинальное выходное напряжение
6.0 V

Энергопитание

Сила тока
4.0 A

Описание

Product description: Step-Up Voltage Regulator U3V40F6 - 6 V 4 A - Pololu 4013

A small size Pololu step-up conver ter module with 6 V output voltage and 4 A current capacity. The inverter input voltage ranges from 1.3 V to 6 V (the start-up voltage is 2.7 V). Typical inverter efficiency ranges from 90% to 95%, depending on input voltage and load. It is equipped with temperature protection, when the temperature threshold is exceeded, the module will shut down.

Step-up converter pinouts 6 V / 4 A.
Leads of the step-up converter module

The board has four leads in the form of six holes for soldering connectors with a raster of 2.54 mm.

  • EN - pin to disable the system when the voltage is below 0.4 V, system on by default: 30 kΩ resistor pulled up from EN to VIN.
  • VIN - input voltage from 2.7 V to 6 V (after starting up the chip, the input voltage may be at least 1.3 V).
  • GND - system ground (common for VIN and VOUT).
  • VOUT - output voltage 9 V.
Dangerous voltage pulses

While connecting power supply to the module, dangerous, short eclectic impulses with large amplitude (so-called pins) may occur, which can permanently damage the system. Pololu company has performed tests which show that for input voltage above 11 V pins can have amplitude large enough to damage the module. To prevent this undesirable phenomenon it is recommended to solder a capacitor of at least 33 uF as close as possible to the pins supplying the converter.

System efficiency

Efficiency is defined as the ratio of output power to input power (power out)/(power in). This is a very important parameter when working with portable power sources. (Batteries and rechargeable batteries), where the working time on a single charge cycle matters. The efficiency of this circuit is between 90% and 95%. The output current is dependent on the input voltage and the system load.

Current efficiency of the U3V40F6 step-up converter.

Pololu step-up converter U3V40F6 6 V / 4 A. Goldpin connectors included.

Specifications of the U3V40F6 step-up converter
  • Input voltage: from 1.3 V to 6 V (the minimum voltage to run the circuit is 2.7 V)
  • Output voltage: 6 V (with 4% accuracy)
  • Typical efficiency: 90% to 95%, depending on input voltage and load
  • Switching frequency: ~600 Hz at high load
  • Energy-saving mode
  • Typical no-load idle current less than 2 mA
  • The 9.5 A switch allows for:
    • Instantaneous input current up to 9.5 A
    • Up to 4.5 A input current for a few seconds
    • up to 4 A input current for a longer time
  • Integrated protection:
    • shutdown due to over temperature
    • soft-start function limits the inrush current and gradually increases the output voltage
    • Output overvoltage protection (typically 16.5V)
    • input current limitation cycle by cycle up to 9.5 A
  • Dimensions: 15.2 x 15.2 x 5.6 mm
  • Weight: 1.5 g
Useful links
  • Manufacturer's website: Pololu #4013
  • Dimensions
  • 3D model

Доставка

Мы доставляем товары напрямую из Германии в Россию курьерской службой или в почтовое отделение. Вы можете выбрать подходящий для вас способ доставки при оформлении заказа. Стоимость доставки зависит от выбранного метода и начинается от 1 350 руб. Время доставки зависит от выбранного города и метода доставки, но в среднем занимает от 10 до 30 дней. Если вы оформите заказ прямо сейчас, мы доставим его в период с 12 июня - 2 июля.

На протяжении уже более 10 лет мы работаем с надежными и проверенными нами службами и предлагаем доставку электрики Pololu в различные города России, такие как  Москва, Санкт-Петербург, Новосибирск, Екатеринбург, Казань, Нижний Новгород, Челябинск, Самара, Уфа, Ростов, Омск, Красноярск, Воронеж и другие.

Вы всегда можете отследить свой заказ, используя номер посылки, сразу как только он будет отправлен к вам с нашего склада.