Step-Up Voltage Regulator U3V40F12 - 12V 3,5A - Pololu 4016

Бестселлер
53916961
1 433 ₽

Мы сотрудничаем с поставщиками электрики Pololu и предлагаем вам самые выгодные предложения на брендовые товары из Америки. Опираясь на свой многолетний опыт, выбираем только лучшие позиции из аутлетов и дискаунтеров, чтобы предоставить вам оптимальные цены, в которые не включены дополнительные расходы на аренду торговых помещений.

Доставка товаров осуществляется прямо с нашего склада до указанного вами адреса. Вы получаете оригинальный товар по цене, которая недоступна для местных магазинов. В нашем интернет-магазине вы всегда найдете широкий ассортимент брендовых товаров с выгодными скидками.

Мы следим за каждым этапом вашей покупки и предоставляем отслеживание заказа на всех этапах, начиная с момента оплаты.

  • Бренд Pololu
  • Доставка из Польши
  • Почта России 23 июня
  • Стоимость доставки заказа в Россию от 1 350 ₽

Сроки доставки указаны ориентировочно и зависят от региона доставки. Подробнее на этой странице

Характеристики

Напряжение до
1.3 V
Напряжение от
12.0 V
Выходное напряжение от
12.0 V
Выходное напряжение до
12.0 V

Прочие свойства

Бренд
Pololu

Энергопитание

Сила тока
3.5 A
Номинальное напряжение
12 V

Описание

Product description: U3V40F12 - step-up converter 12V 3.5A - Pololu 4016

Pololu step-up converter with an output voltage of 12 V and a capacity of 3.5 A. The module is supplied with the voltage from 1.3 V to 12 V (the starting voltage is 2.7 V). Typical converter efficiency ranges from 90% to 95% depending on the input voltage and load. The module has a temperature protection, after exceeding the temperature threshold, it will turn off.

Leads of the step-up converter 12 V / 3.5 A.
Leads of the step-up converter module

The Pololu step-up voltage regulator module is equipped with four outputs in the form of six holes, to which you can solder the included connectors with a pitch of 2.54 mm.

  • EN - pin that turns off the system after applying voltage below 0.4 V, the system is on by default: a 30 kΩ resistor pulled from EN to VIN.
  • VIN - input voltage from 2.7 V to 12 V (after starting the system, the input voltage can be at least 1.3 V).
  • GND - system ground (common for VIN and VOUT).
  • VOUT - 12 V output voltage.
Dangerous voltage pulses

While applying the supply voltage to the module, dangerous, short electric pulses of large amplitude (so-called pins) may appear, which may permanently damage the system. The Pololu company has carried out tests which show that for the input voltage above 11 V the pins may have an amplitude large enough to damage the module. In order to protect against this undesirable phenomenon, it is recommended to solder a capacitor with a value of at least 33 uF as close as possible to the power pins of the converter.

System efficiency

Efficiency is defined as the ratio of the output power to the input power (power out) / (power in). This is a very important parameter when working with portable energy sources. (batteries and accumulators), where the working time per one charging cycle is counted. The efficiency of this system ranges from 90% to 95%. The output current depends on the input voltage and the system load.

Current capacity of the step-up converter U3V40F12.
Step-up converter U3V40F12 12 V / 3.5 A. Goldpin connectors included.
Specification of the step-up converter U3V40F12
  • Input voltage: 1.3 V to 12 V (the minimum voltage to run the system is 2.7 V)
  • Output voltage: 12 V (with 4% accuracy)
  • Typical efficiency: 90% to 95% depending on input voltage and load
  • Switching frequency: ~ 600 Hz under heavy load
  • Energy saving mode
  • Typical idle current less than 2 mA without load
  • The 9.5 A switch allows you to:
    • instantaneous input current up to 9.5 A
    • input current up to 4 A for a few seconds
    • input current up to 3.5 A for an extended period of time
  • Integrated security:
    • too high temperature shutdown
    • the soft-start function limits the inrush current and gradually increases the output voltage
    • output overvoltage protection (typically 16.5V)
    • input current limitation cycle-by-cycle to 9.5 A
  • Dimensions: 15.2 x 15.2 x 5.6 mm
  • Weight: 1.5 g
Useful links
  • The website of the manufacturer: Pololu # 4016
  • Dimensions
  • 3D model

Доставка

Мы доставляем товары напрямую из Германии в Россию курьерской службой или в почтовое отделение. Вы можете выбрать подходящий для вас способ доставки при оформлении заказа. Стоимость доставки зависит от выбранного метода и начинается от 1 350 руб. Время доставки зависит от выбранного города и метода доставки, но в среднем занимает от 10 до 30 дней. Если вы оформите заказ прямо сейчас, мы доставим его в период с 12 июня - 2 июля.

На протяжении уже более 10 лет мы работаем с надежными и проверенными нами службами и предлагаем доставку электрики Pololu в различные города России, такие как  Москва, Санкт-Петербург, Новосибирск, Екатеринбург, Казань, Нижний Новгород, Челябинск, Самара, Уфа, Ростов, Омск, Красноярск, Воронеж и другие.

Вы всегда можете отследить свой заказ, используя номер посылки, сразу как только он будет отправлен к вам с нашего склада.